Well Pumps & Pressure Tanks Repaired & Replaced in Central & Eastern N.C.

No Water? Pump Quit?

Call Us (919) 417-9904

Emergency Service Ready

What We Do

Water Well Pump & Pressure Tank

• Troubleshooting
• Repair
• Replacement
• Installation
• Maintenance Service

Save Money & Extend Pump Life

• Proper pump selection
• Install wire guard
• Install torque arrestor

Well Pumps & Components of All Kinds

• Jet & Submersible
• Industrial
• For Deep & Shallow Wells
• Water Storage Tank
• Pressure Tank
• Pressure Switch

Water Filters & Treatment

• Filtering & Sanitizing
• Whole House Purification
• Drinking Water Systems
• Just Ask!

Well Pump Related

• Wiring
• Trenching
• PVC Pipe Installation

Well Pump & Water Tank Applications

• Residential (Home & Garden)
• Fountain Pumps
• Irrigation & Pond Pumps
• Commercial - Industrial
• Farm & Ranch

Water Quality & Safety

• Water Testing
• Water Filters
• Purification
• Well Inspections
• Well Liners Installed

We also handle well abandonments.

Service Area


We Serve Approx. 80 mile Radius of Raleigh, NC


Hours of Operation


M-F | 8am – 8pm


Sat | 8am – 3pm



Water Filter, Purifier & Treatment Systems – Made in America


If you would like cleaner, healthier water, we can provide water filtration, sanitizers, or treatment systems for the kitchen, or your entire home. We install Water Filters & Water Softeners, Acid Neutralizers, & treat for Iron Filtration & more. 


Well Pump Installation Cost: Save Money By Doing It Right

The cost of a well pump installation is not only what you pay up front, it’s also determined by how long your new pump will last before you have to pay to replace it again. Too many people fall victim to a short-lived well pump, making their true cost of a water well pump system much higher than it should be. Why pay for two well pumps when one would have done the trick?

It’s common for people to replace their well pumps somewhere between 7 and 15 years. Assuming they don’t suffer premature failure, well pumps can last anywhere from 12 to 20 years IF installed properly, which is the way we do it at Walter’s Well Pump & Tank Service. And the best part is, it only requires a few dollars in parts.

This isn’t about about some special, top secret techniques we use. We just do it the way it’s supposed to be done. It costs a little more, very little more, to do it right, but the payoff over the long run is tremendous. It’s the old “ounce of prevention” thing.

How to Get Maximum Life From Your Well Pump, Reduce Replacement Cost & Save Your Family Some Money


All that’s required in doing it right, and making sure you get maximum life out of your new (or current) well pump, is to install two parts that reduce wear on the pump and the electrical wiring that runs down the well and connects to the pump. The first is a torque arrestor, which prevents the pump from twisting severely due to motor torque and banging against the side of the well each time it turns on.

Given the same horse power rating, electric motors generate more torque from a complete stop than gasoline engines, which is one reason that hybrid gas-electric cars can run on electric power only when driving around town in stop and go traffic. When an electric motor is switched on, it goes from zero to top speed in an instant. So each time a well pump turns on, it can generate a pretty severe twisting motion because of the torque that’s generated if there is no torque arrestor in place. This sudden burst of torque will cause the pump to bang against the side of the well, aging the pump and the electrical wiring connects to it.

A failing pressure switch or faulty water storage tank will often cause the well pump to cycle on and off much more often than normal. If a pump that does not have a torque arrestor properly installed begins cycling on and off like this, it may bang against the side of the well so much that the insulation on the electrical wiring is damaged to the point that bare wire is exposed, creating an electrical shock risk.

However, a torque arrestor that has not been fit and installed properly will not provide the protection it should. It’s got to be done right.

The second money-saving well pump installation component is a wire guard. It protects the wiring that supplies power to the pump, preventing it from rubbing against the side of the well when the pump cycles on and off. The wire guide prevents the premature aging and failure described above, which would otherwise lead to a costly service call.

The video below shows a repair being made for this exact problem.

Some people who install and replace well pumps, more than you would think, purposely do not install torque arrestors and wire guards so your pump will fail sooner, which leads to another service call and pump replacement. It’s either that, or it’s just laziness.

Make sure your well pump installation includes a torque arrestor and a wire guard to ensure maximum life from your new pump.


Walter’s Well Pump & Tank Service (919) 417-9940

Post 4

Each domain you create will have a unique username.  Usernames have to be 8 characters or less in length and begin with a letter.  All letters in the username must be lower case.  Numbers are allowed but special characters are not. ach domain will have a password associated with it.  The password

Post 3

Each domain you create will have a unique username.  Usernames have to be 8 characters or less in length and begin with a letter.  All letters in the username must be lower case.  Numbers are allowed but special characters are not. ach domain will have a password associated with it.  The password

Happy Customers


"Walter is great!
Instead of coming out &
charging us $100 to tell us
someone had accidentally
flipped the pump to off.

Yes, we were clueless. He
talked my husband through
finding it & never charged
us at all. What a great guy!
That would have been
EASY money for him.
Great guy!!!!"

Val J. Holly Springs, NC
Review - Service Magic


"Very quick to respond
and fixed the problem
w/in 24hrs. Excellent
service! He is very
knowledgable about
every and any type
of well."

E.D. - Service Magic


"Fast service, friendly &

T. R. - Benson, NC Well
Pump - Service Magic


"Prompt, courteous and fair.
Fixed our problem without delay."

Review: Bill W. Chapel Hill,
NC - Serv. Magic


"Quick response, excellent
communication, great work,
nice follow-up. Can't say
enough good things. :)"

Review: J.M. - Raleigh, NC
Well Pump System - S. Magic



"I give him 5/5 Stars on professionalism,
time to complete job, cleanup, available equipment options,
follow-up calls, and referral services.

He had a great attitude and fully
explained everything required
complete the job before he began work.

The price he offered was half of some other contractors I had spoken with. He arrived on time (actually a little early – which was great!) He even called later that evening and the following day to make sure everything was working correctly.

I would highly recommend Walter Upchurch if you need your well system repaired."

Dan - Durham, NC Ser. Magic